Of course we could have paid 430 Euro for an Axis IPv6 enabled cam, but since we are on a roll with Raspberry Pies, Ben decided to make his own IPcam.
The left side of the picture shows the white ethernet cable, going to the utility closet where the router and switch are. It is connected from the Raspberry Pi to the switch. The black cable to the right goes to the cam outside the front door. Ben had to solder the cable back to 1 piece after he cut it to fit through the wall, so we'll leave it hanging like this tonight, to see if the solder holds :)
When this setup proves successful, we might change the cam itself, because the image quality is not very good.
Geen opmerkingen:
Een reactie posten